References to EU regulation or EU websites in our guidance will not be an accurate description of your obligations or rights under UK law.read more
Commission Regulation (EU) No. 1321/2014, AMC2 Part 145.A.50(d), (AMC2) addresses conditions under which components can be removed from an aircraft and be issued with an EASA Form 1, provided that they are approved by an appropriately rated Part-145 aircraft maintenance organisation (AMO).
The Regulation places the responsibility to correctly identify and follow the requirements on the AMO issuing a Form 1. There is a potential for the AMO to use AMC2 in a way it was not intended.
The CAA policy is designed to address any possible misinterpretation by outlining the circumstance each paragraph in AMC2 is designed to address and explain the application of AMC2 when certifying aircraft components ready for release to service.
In accordance with Part-145.A.50(d), a certificate of release to service is issued by appropriately authorised staff at the completion of any maintenance on a component, whilst the component is off the aircraft. It is assumed that some maintenance would have been performed on the component to establish that it is in a serviceable condition and ready to be installed on an aircraft that falls within the scope of EASA Basic Regulation.
However, Part 145 provides for release of a used aircraft component to service, using EASA Form 1 as the release document, without any substantive maintenance being performed. This is on the basis that conditions detailed in AMC2 to Part-145.A.50(d) have been satisfied, assuring the component’s serviceability.
The term ‘maintenance’ is defined in the Article 2 of the Regulation (EU) No. 1321/2014 as any one or combination of overhaul, repair, inspection, replacement, modification or defect rectification of an aircraft or component, with the exception of pre-flight inspection.
AMC2 refers to terms a ‘Member State registered aircraft’ and a ‘serviceable aircraft’. These two concepts are not defined in the Regulation and therefore prone to be misconstrued, particularly when being considered in isolation. To help provide some clarity the two concepts are expanded on below, within the context of the Regulation (EU) No. 1321/2014.
For the purpose of the AMC2, a Member State registered aircraft is considered an aircraft which:
Through the issuance of an EASA CofA, the aircraft is certified as being in compliance with its Type Certificate which itself would have been either approved or validated by EASA. A valid EASA CofA therefore confirms aircraft compliance with EASA safety standards. This process ensures that the aircraft safety and airworthiness assessment is carried out at the point of entry on to the EASA MS aircraft register.
AMC2 para 2.6 refers to used aircraft components removed from a ’serviceable aircraft’. When looking at serviceability of an aircraft, serviceability of its components must be assured. AMC2 2.6(b) states that ‘the aircraft component may only be deemed serviceable if the last flight operation with the component fitted revealed no faults on that component/related system’. A full compliance with subparagraph 2.6.1 is required for the component to be deemed serviceable.
A serviceable aircraft is one which has been admitted into the EASA system via a CofA, (M.A.904 applies for aircraft imported from a third country) and is in an airworthy condition (as per ICAO Airworthiness Manual doc 9760, meaning it conforms to its approved design and is in a condition for safe operation). A component removed from such an aircraft can be deemed serviceable and airworthy through the mechanism provided for in para 2.4 – 2.7.
The first determination in assessing applicability of AMC2 to used aircraft components is whether the aircraft from which the components have been removed is registered in an EASA Member State.
The second determination is linked to the airworthiness status of the aircraft and the issue of an EASA CofA. If a valid CofA has been issued at the point of entry on to the Member State aircraft register it means that the aircraft has been determined to conform with the applicable European Regulations. Providing that the aircraft is maintained in a serviceable condition AMC2 para 2.6 can be applied. Serviceable used aircraft components can be removed and certified by an A-rated AMO for aircraft within the scope of their approval.
It is possible for an aircraft to be on the register of a Member State whilst its EASA CofA has been surrendered or is no longer valid, for example when the Airworthiness Review Certificate (ARC) validating EASA CofA has expired or it has not been renewed or extended.
Given that such aircraft has held a valid EASA CofA since entering the aircraft register of a Member State, the requirement for aircraft to conform to an EASA approved/accepted type design would have been satisfied. In this case AMC2 2.7 applies where serviceable used aircraft components can be removed and certified by an A-rated AMO with specific aircraft type approval.
The same principle applies in cases where a component is removed from a Member State registered aircraft which, at the point of determination, has been removed from service though the aircraft has held a valid EASA CofA. The aircraft would have conformed with the applicable European Regulations and therefore serviceable used aircraft components can be removed and certified by an A-rated AMO with specific aircraft type approval following AMC2 para 2.7.
However, if a Member State registered aircraft has never held a valid EASA CofA since entering that register, the aircraft’s airworthiness and safety standard would not have been assessed in accordance with European regulations. Any component from such aircraft, although it can be removed by an A-rated AMO, it can only be certified by an appropriately rated B or C-rated AMO where the engine and components are specified within its approval, as stated in AMC2 para 2.8.
In line with the first determination, any component removed from an aircraft that is not registered in an EASA Member State, AMC2 para 2.8 applies. An A-rated AMO can remove the component though only a B or C-rated AMO where the engine and components are specified within its approval can release it to service.
Similarly, AMC2 para 2.8 is also applicable to any used aircraft component that is maintained by an organisation not approved in accordance with Part -145.
The AMC is clear that in the case of serviceable aircraft components removed from an aircraft that is not registered in an EASA Member State may only be issued with an EASA Form 1 if the component is leased or loaned from Part-145 approved AMO providing that the maintenance organisation retains control of the airworthiness status of the component. Such controlled component can then be loaned or leased with the intent to be installed on an EASA Member State registered aircraft. In this case, subparagraph 2.6.2 of the AMC applies.
This flowchart is provided to aid the correct determination of applicable provisions.
Appropriately rated maintenance organisation – means an organisation with an approval class rating for the type of component or for the product in which it may be installed.
Part-145 approved maintenance organisation - a maintenance organisation approved by EASA under Part-145 which is located in an EASA Member State, is subject to EASA enforcement regime and falls under the jurisdiction of European Court of Justice.
Serviceable aircraft – is an aircraft which has been admitted into the EASA system via a Certificate of Airworthiness and is in an airworthy condition, i.e. it conforms to its approved design and is in a condition for safe operation.
Serviceable aircraft component – a component that has been fitted to an aircraft which when it was last flown, no faults were revealed of the system within which the component operated.Type design – the aircraft conforms to a type design approved under a type-certificate and any supplemental type-certificate, change or repair approved in accordance with Regulation (EU) No. 748/2012 (Part 21) and is in a condition for safe operation.
Read all @UK_CAA
Economic regulation of Heathrow Airport Limited
27 April, 2021
UK Civil Aviation Authority confirms regulatory approval for JetBlue
19 April, 2021
Major safety boost for offshore helicopters moves closer
25 March, 2021
Read all News
13 May, 2021
International Civil Aviation Day
7 December, 2020
Read All Blogs